Guide · Summer cooling
Heat pumps & ACs in a heat wave
What a heat pump or central AC should do on a 100°F Tri-Cities afternoon, how to help it keep up, and the warning signs of a weak capacitor, pitted contactor or dirty coil.

Guides
Heat, wind-blown dust and winter fog each leave their mark on equipment here. These guides explain what to watch for and what you can safely check yourself.
Guide · Summer cooling
What a heat pump or central AC should do on a 100°F Tri-Cities afternoon, how to help it keep up, and the warning signs of a weak capacitor, pitted contactor or dirty coil.
Guide · Outdoor unit care
How Tri-Cities west winds, blowing dust, cottonwood fluff and tumbleweeds clog heat pumps and AC condensers, how to rinse a coil safely, and which jobs to leave to a technician.
Guide · Winter heat pumps
Why Tri-Cities heat pumps steam, pause and defrost so often during winter inversions, how to tell normal defrost from a coil that stays iced, and what the AUX light means.
Guide: appliances
Why a garage or shop refrigerator strains through 100°F afternoons and can let its freezer thaw in January, which parts wear first, what owners can do, and when to book a repair.
Talk to us
If the coil is matted, the fins are flattened, or the system struggles after a windstorm, reserve a date and arrival window on the site or call any day, 8 AM–7 PM. The office phones back to confirm.
One photo per tab from our service calls. Tap a tab, or let the file turn on its own.

01 / 12
Digital gauges hang by the outdoor unit while the heat pump runs. Superheat and subcooling show whether the charge, a valve or the defrost board is the problem.
Read the service page
02 / 12
An older condenser under test with hoses on the service ports. The capacitor, contactor and fan motor get checked before anyone talks about refrigerant.
Read the service page
03 / 12
The burner compartment of a gas furnace, open. We follow the start-up order, inducer, pressure switch, igniter, flame sensor, until the step that fails.
Read the service page
04 / 12
A recovery machine and cylinder beside an outdoor unit. On a replacement, the old refrigerant is pulled into the cylinder instead of the air.
Read the service page
05 / 12
A ductless outdoor unit with a gauge set on it. Mini-splits get the same pressure and temperature readings as a central system, plus a look at the line-set insulation.
Read the service page
06 / 12
Gauges on a condenser during a seasonal visit. Spring visits wash the dust out of the coil; fall visits test defrost and heat strips before the fog weeks.
Read the service page
07 / 12
Gauges connected to a built-in refrigerator's sealed system. Leak searches, brazing and recharges happen in the kitchen, so the fridge stays where it is.
Read the service page
08 / 12
A top-load washer with the top panel raised. Lid switch, drive coupler and drain pump are all within reach once the top comes up.
Read the service page
09 / 12
An electric dryer opened up in a laundry room. The thermal fuse, the heating element and the vent run behind the machine get tested together.
Read the service page
10 / 12
Door open and racks out on a dishwasher. A puddle left behind after the last rinse sends us to the filter screen, the pump and the hose route under the sink, in that order.
Read the service page
11 / 12
A five-burner gas range ready for testing. Burner igniters, the spark module and the bake igniter's amp draw are measured before a part is ordered.
Read the service page
12 / 12
A French-door refrigerator open for diagnosis. Slow ice starts with the water: the inlet valve, the filter and a fill tube that can freeze shut.
Read the service pageBook a visit
One slip, filled top to bottom. The office phones to confirm the visit, and the technician calls again when on the way.
Every number below is a public state record. Look each one up on L&I Verify, or read what each license allows on our licenses page.
What our licenses cover