Skip to content
Kennewick, Pasco, Richland and nearby townsCalls answered daily, 8 AM–7 PM
LarchHVAC & Appliance (509) 567-3110
Dryer drum and door during a repair visit

Kennewick appliance repair

Appliance Repair in Kennewick, WA

Hardness in Kennewick tap water rises and falls over the year, and garage refrigerators bake each summer. Our technicians fix refrigerators, ice makers, laundry machines, dishwashers and ranges, and you get each repair price on paper before a new part leaves its box.

  • Fee folds into the repairYou learn the diagnostic charge before anyone drives out. Okay the fix and that charge melts into its total; turn it down and only the trip itself gets billed.
  • Price in writing firstWe test, write the repair price down, and wait for your go-ahead before a single part comes off.
  • Warranty on the invoiceEach finished repair leaves with its warranty terms written on the invoice.

Short answer

We repair refrigerators, freezers, ice makers, washers, dryers, dishwashers, ranges and ovens across Kennewick under our 07D Appliance Repair specialty. Frequent local faults include scaled inlet valves, jammed drain pumps, blown dryer thermal fuses and overworked garage refrigerators. A technician diagnoses the problem, writes up the cost, and proceeds only with your approval.

Why does Kennewick water matter for your appliances?

It decides how fast valves and screens scale up. Kennewick's supply mixes Columbia River intake with Ranney collector wells, and hardness lands anywhere from about 50 to 200 parts per million, near 5 to 14 grains a gallon, depending on the month. In the harder months, minerals gather on the dishwasher inlet valve screen, the refrigerator water valve and the washer's fill screens, which slows filling and leaves a cloudy film on glassware.

Heat is the other local factor. Garage-kept refrigerators and chest freezers in Kennewick may face 100°F afternoons anywhere from mid-May to early September, so the compressor runs nearly nonstop while the condenser coil underneath gathers dust. Before calling any cooling complaint a compressor failure, our technicians check the evaporator fan, the defrost heater and its bimetal thermostat, plus the condenser fan.

Which appliance problems do Kennewick homes call about?

  • Dishwasher fills slowly and spots the glasses

    Likely cause
    A scaled screen in the inlet valve or a sluggish valve solenoid, worse in months when city water runs harder.
    What we do
    We measure fill volume, clean the inlet valve screen or fit a new valve, and look over the wash pump and spray arms for mineral crust.
  • Garage refrigerator warm on hot days

    Likely cause
    A dust-matted condenser coil, a weak condenser fan, or an evaporator iced solid after the defrost heater failed.
    What we do
    We clean the coil, test the defrost heater and its thermostat, and make sure the evaporator fan pushes air through the freezer.
  • Dryer tumbles but stays cold

    Likely cause
    A lint-choked vent that overheated the drum and blew the thermal fuse, or a burned-open element or weak gas igniter.
    What we do
    We test the thermal fuse, element or igniter, then check vent airflow so the replacement fuse is not the next part to fail.
  • Washer halts mid-cycle, drum full of water

    Likely cause
    A stray sock, coin or hair tie wedged at the drain pump inlet, or a pump motor no longer turning.
    What we do
    We clear or replace the drain pump, then inspect the door boot and hoses for the tear or debris that caused the jam.
  • Oven never reaches the set temperature

    Likely cause
    A weak bake element, a gas oven igniter whose current draw sits below what the safety valve needs, or a drifting temperature sensor.
    What we do
    We read element resistance or igniter amperage plus the sensor, swap whichever part failed, and confirm the oven holds temperature.

What can Kennewick owners check before booking?

A few quick looks narrow things down. Give the refrigerator breathing room at the back, and confirm a garage unit is rated for garage temperatures, since some models are not. For a dryer, step outside and feel the exhaust at the vent hood while it runs; a weak puff means a lint-clogged vent. If your ice maker's cubes have shrunk, the harder water of some Kennewick months may be narrowing the screen in the refrigerator's water valve.

Visits are scheduled with the river crossings in mind. Our technicians move between Kennewick, Pasco and Richland on the Cable Bridge, the Blue Bridge and the west-bank arterials, and each one calls before pulling up. Brands on our list include Whirlpool, GE, Maytag, LG, Bosch, KitchenAid, Speed Queen, Frigidaire, Electrolux and Kenmore, and on the Samsung side we handle washers, dryers, ranges and dishwashers.

Which Kennewick neighborhoods see which appliance repairs?

Creekstone

Builder-grade appliances that came with these 2000s and 2010s homes are now aging side by side. Dishwasher pumps, washer door boots, refrigerator ice makers and range igniters often start failing in the same stretch of years, so we check related parts while we are already in the kitchen or laundry.

Hansen Park

Established homes around Hansen Park may run the laundry pair from the garage or a back hall, with a long dryer vent run. Lint packed into that run trips thermal fuses and stretches dry times, so on these calls we measure exhaust airflow along with testing the dryer itself.

Panoramic Heights

Up on the hill, west wind presses against dryer vent hoods and can hold the flapper shut, and garages heat up through long afternoons. We look at the vent hood, the refrigerator's condenser and door gaskets, and the freezer's defrost system while we are at the house.

Twelve tabs, twelve kinds of work

One photo per tab from our service calls. Tap a tab, or let the file turn on its own.

Built-in refrigerator with gauges connected to the sealed system

01 / 12

Refrigerator repair

Gauges connected to a built-in refrigerator's sealed system. Leak searches, brazing and recharges happen in the kitchen, so the fridge stays where it is.

Read the service page
1 / 12

Common questions

Is it worth repairing a refrigerator that's about ten years old?

Often, yes, when the fault is a fan motor, defrost heater, thermostat, door switch or water valve. Sealed-system faults, like a pinhole leak in the evaporator or a seized compressor, are a different conversation, and we write out that cost so the number sits beside what a new unit would cost. We will tell you plainly when a repair isn't a good use of your money.

Can Kennewick's hard water damage a washer or dishwasher?

It can slow them down over time. Kennewick water moves between about 5 and 14 grains a gallon across the year, and minerals gradually narrow inlet valve screens and coat dishwasher heating elements. A monthly cleaning cycle helps. When filling turns sluggish or a valve hums without opening, our technician cleans or replaces the valve and checks the rest of the fill path.

How is the appliance diagnostic fee handled?

The diagnostic fee pays for the Kennewick visit, and the office gives you the figure as part of booking. Approve the written repair price and the fee is tucked inside that total. Decide to stop after the diagnosis, and the fee is all that gets billed. Thermal fuses, door switches, pumps and valves ride on the truck, so those repairs can sometimes wrap up that day.

Can your technicians fix gas ranges and gas dryers?

Yes, we repair gas ranges, ovens, cooktops and gas dryers, including the igniters, valves and sensors inside the appliance. Running or connecting gas supply lines is outside our scope. If gas odor turns up at any point, clear everyone out, reach 911 or the gas utility after you're outdoors, and book the appliance visit once the house is declared safe.

Talk to us

Need a Kennewick appliance looked at?

Schedule online with a day and an arrival window that suit you, or call 8 AM to 7 PM daily. The office confirms by phone, and a reply in Spanish is available on request.

Book a visit

Set up a visit on one short slip

One slip, filled top to bottom. The office phones to confirm the visit, and the technician calls again when on the way.

  • Fee named before the visit and counted inside any repair you approve.
  • Common parts on the truck capacitors, contactors, igniters, sensors, pumps, belts and door switches. Ordered parts are quoted first.
  • English or Spanish choose the language for our reply at the bottom of the slip.

(509) 567-3110

Request a visit

Pick the equipment, a day and a window, then tell us where to come. We call back to confirm before anyone drives out.

What needs service

Which day

Arrival window

What is going on, and where

Your request

The diagnostic fee is named when we call and is counted inside any repair you approve. We use these details only to schedule your visit.

Washington L&I licenses on record

Every number below is a public state record. Look each one up on L&I Verify, or read what each license allows on our licenses page.

What our licenses cover
CallBook